• 3D baseball chocolate candy mold
• super white candy coating
• red candy coating
• squeeze bottle
• parchment triangles

Melt candy coatings. Cut mold apart at lines. Cut a hole at the base of the 3-D mold. Put the front and back of the mold together and secure with bulldog clips, binder clips or paper clips. The tighter the mold is clipped together, the cleaner the seam will be. Fill a squeeze bottle with the melted white coating. Fill the mold with coating through the cut hole and set in the freezer upside down so candy does not run out. When candy is set, remove the clips and take the mold apart, carefully releasing the candy from the mold. If necessary, trim the seam with a sharp knife. Using a parchment bag filled with red candy coating, pipe on baseball stitching.